Tower Clamp Hose

Tower Clamp Hose

Toyota VSC light?

2004 Toyota 4Runner V6 4WD I changed the spark plugs, 4 last week (no problem Driving several hours) and from 2 to date, driver's side rear of 2, and an hour later, seeing the audit Engine and VSC came and missed. I saw responses prior to the VSC light come on just because the check engine light is on. I checked my cables, and click the connector into the coil turn a little better and the engine running smoothly again, but the lights are lit. I only ran about 5 minutes since. I also have a small tube at the rear of the block housing for a small square at the bottom of the absorption of "Upper Deck" takes me to reach the plugs. I missed the right of the clamping ring compression is already connected. I would say that is rotten. I taped around the pipe to thicken until it can get a hose nine. Thus, the light went for itself whether the electrical connector is loose and the cause has been fixed? Where is the OBD connector? Thank you Jeff

The light turns off by itself even if the team determines that no malfunction today. I would like to get the pipe replaced. After that, you can reset the computer to disconnect the battery for a few minutes (10 minutes) to be sure. The light came only if there is still a problem.